Safety: This machine conforms to all relevant European CE Health and Safety Directives EN 50081-1, 580081-1, 73/23/EEC, EN 61010-1.
This series environmental chamber is designed to fit between the columns of a materials testing machine on a suitable mounting. Ports located in the upper and lower surfaces of the chamber allow pull rods to be inserted to which grips and fixtures are attached for operation within the chamber.
It adopts liquid nitrogen as cooling media or compressor for cooling and electric resistance wire for heating.
It can be with large observation window if video extensometer will be configured for strain measurement under the climatic condition.
It consists of chamber body, heating unit, intelligent PID temperature controller, temperature sensor, high & low temperature grips/fixtures, liquid nitrogen container/LN2 Dewar and moving trolley etc.
|Chamber||Temp. Range||-190°C to +350°C||Including the corresponding pull rod|
|Temp. Fluctuation||±3°C or customized|
|Effective Space||300x240x450mm(W×D×H)Or customized|
|Heating mode||Heating by electric resistance wire|
|Cooling mode||Cooling by LN2 or compressor|
|Moving Bracket||Equipped according to the dimension of the load frame||Adjusting height 100mm|
Electromechanical Universal Testing Machine
Hydraulic Universal Testing Machine
Impact Testing Machine
Dynamic Testing System
Creep and Rupture Testing Machine
Compression Testing Machine
Upset Testing Machine
Bending Testing Machine
Torsion Testing Machine
Cupping Testing Machine
Spring Testing Machine
Friction Wear Testing Machine
Load Cell Calibration System
High Temperature Axial Extensometer
Fracture Mechanics Clip-on Gages
Transverse and Diametral Extensometers
High Temperature Transverse and Diametral Extensometers
Rock,Concrete and Asphalt Extensometers
Averaging,bi-axial and axial torsional extensometers
Bolt prool,lap shear and specialty extensometers
Knife Edges for Extensometers
Interface Electronics and Signal Conditioners
Sample Preparation Machine