GB/T2039, GB/T 10120, EN ISO 204 and ASTM E139 etc
Specimen rupture switch senses when the specimen fails and stops the timer
Compact load frame with one lever arm with a load accuracy of less than ±0.5%
Hardened knife edges and V-blocks for long life fulcrum point
Over travel limit switch assembly
The draw head is designed to automatically adjust during a test to compensate for specimen elongation and keep level horizontal.
This adjustment keeps the lever arm level and provides an accurate lever arm ratio. This process provides an accurate and constant load on the specimen.
Interface can be connected to computer and the testing graph of Strain-stress, temperature display and data can be displayed and processed by computer.
Standards: GB/T2039, GB/T 20120, EN ISO 204 and ASTM E139, ISO 7500-1etc.
Fulcrum material is high strength tool steel, heat treated to 50-55HRC.
The material for frame is IS226 mild steel (MS).
Spirit level is mounted to indicate beam position.
There are two modes for unloading, one is manual, and the other is motorized.
Lever horizontality-adjusting system control: optical fibre sensor adopted for upper & lower main generation signal source.
Manual unloading mechanism: it can be adjusted manually when power failure happened suddenly, which can effectively protect the machine and specimen during test.
Free standing load frame with small footprint optimizes floor space and no special foundation.
Effective measuring range
Relative error of the load display
Min. dead weight
Lower chuck speed
Chuck speed accuracy
Standard Size of specimen
Creep test: φ10x100mm; Rupture strength test: φ10x50mm; Different adaptors can be provided per the required standards;
Load frame dimension
Load frame weight
High temperature furnace & Temperature-controller
Length of effective soaking zone
Furnace pipe & electric furnace size:
Furnace inner chamber: φ90mm×380mm (L), Furnace outside: φ300mm ×420mm (L)
Furnace shell temperature
SHIMADEN, Japan with Sensitivity of 0.1°C
K type, 3 pcs
By LVDT Heidenhain from Germany
5mm or 10mm
Load frame 220V±10%, 50Hz Furnace 380V±10%; 50Hz±2%, 3KW
Electromechanical Universal Testing Machine
Hydraulic Universal Testing Machine
Impact Testing Machine
Dynamic Testing System
Creep and Rupture Testing Machine
Compression Testing Machine
Upset Testing Machine
Bending Testing Machine
Torsion Testing Machine
Cupping Testing Machine
Spring Testing Machine
Friction Wear Testing Machine
Hydrostatic Pressure Testing MAchine
Load Cell Calibration System
High Temperature Axial Extensometer
Fracture Mechanics Clip-on Gages
Transverse and Diametral Extensometers
High Temperature Transverse and Diametral Extensometers
Rock,Concrete and Asphalt Extensometers
Averaging,bi-axial and axial torsional extensometers
Bolt prool,lap shear and specialty extensometers
Knife Edges for Extensometers
Interface Electronics and Signal Conditioners
Sample Preparation Machine
Model: MRC Series
MRC series mechanical creep and rupture testing machine with single-lever structure is designed for long-term creep and stress rupture test applications. The series mechanical creep and rupture testing system is mainly for the metallic materials under room or elevated temperature according to GB/T2039, GB/T 20120, EN ISO 204-2009 and ASTM E139. The creep and rupture testing machine can also maintain constant loads for extended periods of time. Through the mechanical advantage of the lever arm loading system, constant loads can be maintained with a high degree of accuracy for long duration. This creep and rupture tester uses dead weights without continuous operation and the dependency of a mechanically powered drive. The creep and rupture testing system is an ideal equipment for metallurgy manufacturer, research institute, colleges and other relevant factories and mines.